Sonarworks SoundID Ref Spk & HP w Mic EDU, School version@+ATTENTION! This software version can only be purchased under certain conditions set by the manufacturer! Please be sure to read our notes on EDU conditions in the ""Smart Navigator"" at the bottom of this page *before* adding the item to your shopping cart! @+, Bundle of measuring microphone and software for loudspeaker and headphone calibration@+@+, Frequency response correction for studio monitors and headphones for the most linear reproduction possible, Enables better assessment of recordings and mixes, Room analysis and automatic room size calculation using numerous measuring points, Audio Calibration Engine for the most accurate adjustment possible, Any number of profiles for loudspeakers can be stored, Comes with calibration curves for over 280 different headphone models, Target curves can be individually adjusted in real time, Translation Check simulates more than 20 different devices and device types for the accurate realisation of a mix, Three selectable filter modes: Zero Latency, Mixed and Linear Phase to optimise filter quality and latency for different listening situations, Additional settings for mono, dry/wet and safe headroom, Only available in the app: MIDI mapping for various parameters and user presets for predefined output configurations, Measurement microphone with pre-polarised electret condenser capsule, Frequency range: 20 - 20.000 Hz with measurement protocol, Polar pattern: Omnidirectional, Sensitivity: 14mV / Pa, Inherent noise: 24 dB, Signal-to-noise ratio: 70 dB, Dynamic range: 106dB, Maximum sound pressure level: 132 dB SPL, Requires 48V phantom power, Connection: XLR 3-pole, Calibration file for 30° off-axis measurement in native Sonarworks format for use with SoundID Reference software, Calibration file for 0° on-axis measurements in TXT format