Spark Arc ProThe lightest and highest performing splitboard bindings in the world - made with incredible attention to detail and no compromises.Arc Pro splitboard bindings feature all the same great assets as our standard Arc bindings - T1 technology, Tesla snap ramps, maximum baseplate cutouts, surfy highbacks, Pillow Line Straps with a flex window - but they are tuned up with premium materials and custom versions. We used carbon-reinforced nylon in the highbacks, full Pebax® plastics for the straps, ladders and adjusters, 7075 aluminum in the heel loops allowing us to make them thinner and lighter, 7 custom made screws and hardware pieces, and lastly, we hollowed out the steel pivot pins to shave a few more grams. Learn more about the Pro Series on the Pro Binding Tech page. In the Box: Bindings, Tesla touring brackets, T1 heel rests, aluminum mounting screws, and Spark pocket tool.What else do I need? A set of Spark Pucks or Spark Canted Pucks.Weight: 1.23 lbs/ea (557g) - 2.46 lbs/pr (1114g) – MediumPebax® Pillow Line StrapsArc Pro Pillow Line Straps are made with Pebax® plastics, a premium material most often found in high-end ski boots as it provides consistent stiffness and improved toughness in cold temperatures while being 20% lighter. Like our standard pillow line straps, they are ultradurable, comfortable, waterproof, one-piece molded construction, and produced 100% in-house. Strap pillows are thin and flexible for a comfortable, conformed fit, while thicker ribs are held off the boot and provide support for a uniquely responsive ride. Arc Pro ankle straps are smaller around the boot than the Surge Pro and feature a flex window for max agility while maintaining support. The toe straps come in one construction for both Arc Pro and Surge Pro models, and are designed to be used as a toe cap but also fit traditionally over the top.Carbon Reinforced HighbacksThe Arc Pro Rip ‘N’ Flip highback is made from carbon-reinforced nylon in a ratio designed for medium flex and a surfy feel. This material blend is more responsive, lighter, and stiffer than our standard glass-reinforced highbacks. All Rip ‘N’ Flip highbacks incorporate a tool free forward lean adjuster (FLAD) for complete customization from 0° to 22° in ride mode. The Forward Lean Adjuster toggles easily between forward lean position and -13° touring position for easy transitions.Whammy Bar Climbing WireA single fatty climbing wire is built into the baseplate with a side arm lever for easy position changes on the steeps. You can switch easily from stowed, to low (12°), to high (18°) and back again while touring.Pro HardwareWeight savings add up by replacing stainless steel hardware with custom-made 7075-T6 aluminum hardware. Aluminum parts are 65% lighter than our standard stainless steel parts and are made with hex drives instead of phillips heads which are less likely to strip.Puck CompatibilitySlide them on and snap the ramp down. Snap the ramp up and slide them off. The most...